CONTROL SYSTEMS > Select Cable
REMOVAL
1. Shift the select lever to “N” range.
2. Disconnect the ground cable from battery. NOTE">
NOTE:
For model with battery sensor, disconnect the ground terminal from battery sensor.
3. Lift up the vehicle.
4. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">
5. Remove the center exhaust cover.
6. Remove the snap pin and washer from the shifter arm.
CAUTION:
Do not apply extra overload while holding the part (A).
(A) | Shifter arm |
(B) | Snap pin |
(C) | Select cable |
(D) | Washer |
7. Remove the plate assembly from the transmission case.
(A) | Select cable |
(B) | Plate ASSY |
8. Disconnect the cable from arm COMPL.
CAUTION:
Do not apply extra overload while holding the part (A).
(A) | Adjusting nut |
(B) | Arm COMPL |
9. Raise the claw of clamp to remove the cable from bracket.
(A) | Claw |
10. Remove the select cable from plate assembly.
Dtc p1531 battery current sensor circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1531 BATTERY CURRENT SENSOR CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION&q ...
Installation
MECHANICAL(H4DO) > V-beltINSTALLATION1. V-BELTInstall in the reverse order of removal.CAUTION:• When reusing the V-belt, wipe off dust and water with cloth.• Do not use the V-belt if there is any oil, grease or coolant on the belt.• Be careful not to rub the V-belt end surface w ...
Dtc p0451 evap system (cpc) pressure sensor/switch circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0451 EVAP SYSTEM (CPC) PRESSURE SENSOR/SWITCH CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, ...