Subaru Crosstrek Service Manual: Removal

1. PITCHING STOPPER

1. Disconnect the ground cable from battery. NOTE">

NOTE:

For model with battery sensor, disconnect the ground terminal from battery sensor.

2. Remove the clip (A) from the air intake boot.

3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).

4. Loosen the clamp (C) which connects the air intake boot and throttle body.

5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.

6. Remove the pitching stopper.

1. Disconnect the ground cable from battery. NOTE">

NOTE:

For model with battery sensor, disconnect the ground terminal from battery sensor.

2. Lift up the vehicle.

3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">

4. Remove the center exhaust cover.

5. Set the transmission jack under the transmission. Make sure that the support plate of transmission jack does not touch the oil pan.

6. Remove the transmission rear crossmember.

7. Remove the rear cushion rubber.

Inspection

Installation

Other materials:

Caution
MECHANICAL(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, fender c ...

Inspection
DRIVE SHAFT SYSTEM > Front Drive ShaftINSPECTIONCheck the removed parts for damage, wear, corrosion etc. If faulty, repair or replace.• PTJ (pillow tripod joint)Check for seizure, corrosion, damage, wear and excessive play.• EBJ (high-efficiency compact ball fixed joint)Check for seiz ...

Engine low oil level warning light
This light illuminates when the engine oil level decreases to the lower limit. If the engine low oil level warning light illuminates while driving, park the vehicle in a safe and level location, and then check the engine oil level. When the engine oil level is not within the normal rang ...