Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control Device

REMOVAL

1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">

2. Remove the inhibitor switch. Inhibitor Switch > REMOVAL">

3. Remove the oil pan and oil strainer. Oil Pan and Strainer > REMOVAL">

4. Shift the manual plate to “N” range, and remove the spring pin.

NOTE:

Prevent the spring pin from dropping in the transmission using paper towel etc.

5. Remove the detent spring.

6. Remove the bolt, and remove the shifter arm shaft.

NOTE:

Do not damage the lip of oil seal press-fitted in the case.

7. Remove the manual plate from the shifter arm shaft, and remove the shift connecting rod of the manual valve.

(A)

Parking rod

(B)

Manual plate

(C)

Shift connecting rod

8. Remove the manual plate and parking rod.

9. Remove the manual valve.

10. Remove the extension case. Extension Case > REMOVAL">

11. Remove the parking support.

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control DeviceINSPECTIONMake sure that the manual plate and detent spring are not worn or otherwise damaged. ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control DeviceINSTALLATION1. Install the parking support.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)2. Install the extension cas ...

Other materials:

Installation
PARKING BRAKE > Parking Brake CableINSTALLATION1. Install each part in the reverse order of removal.Tightening torque:Cable clamp: 18 N·m (1.84 kgf-m, 13.3 ft-lb)Rear wheel: Except for C4 model120 N·m (12.24 kgf-m, 88.5 ft-lb)Rear wheel: C4 model100 N·m (10.20 kgf-m, 73.8 ft- ...

Inspection
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEDetecting condition:Defective harness connectorTrouble symptom:Communication is impossible between the TPMS & keyless entry CM or TPMS CM and the Subaru Select Monitor.WI ...

Inspection
CLUTCH SYSTEM > Release Bearing and LeverINSPECTION1. RELEASE BEARINGCAUTION:Since this bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or any other solvent when servicing the clutch.1. Check the bearing for smooth movement by applying force to the bearing in the ...

© 2016-2022 Copyright www.sucross.com