Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed Sensor

REMOVAL

CAUTION:

• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.

• When secondary speed sensor is removed, CVTF leaks. After installing the secondary speed sensor, adjust the CVTF level.

1. Lift up the vehicle.

2. Remove the harness connector from secondary speed sensor.

3. Remove the secondary speed sensor.

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the che ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSTALLATIONCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If ad ...

Other materials:

Dtc b1647 side satellite sensor bus lh lost communication
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1647 SIDE SATELLITE SENSOR BUS LH LOST COMMUNICATIONDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (L ...

Dtc p2012 tgv control circuit low bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2012 TGV CONTROL CIRCUIT LOW BANK 2DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION"& ...

Installation
CLUTCH SYSTEM > Master CylinderINSTALLATION1. Install the master cylinder to the body, and connect the clutch pipe and the tank hose.Tightening torque:T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb)2. Connect the push rod of the master cylinder, and install the ...

© 2016-2026 Copyright www.sucross.com