Subaru Crosstrek Service Manual: Removal

CAUTION:

• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.

• When secondary pressure sensor is removed, CVTF leaks. After installing the secondary pressure sensor, adjust the CVTF level.

1. Disconnect the ground cable from battery. NOTE">

NOTE:

For model with battery sensor, disconnect the ground terminal from battery sensor.

2. Lift up the vehicle.

3. Remove the secondary pressure sensor connector.

4. Remove the secondary pressure sensor.

Inspection

Installation

Other materials:

Installation
EXTERIOR BODY PANELS > Rear GateINSTALLATION1. REAR GATE PANELCAUTION:The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.1. Install the hinge - rear gate to the vehicle body.2. Temporarily install the panel - rear gate to the hinge - rear ...

Light control and wiper control levers/switches
Windshield wiper Mist Windshield washer Rear window wiper and washer switch Wiper intermittent time control switch Wiper control lever Light control switch Fog light switch Headlight ON/OFF/AUTO Headlight flasher High/Low beam Turn signal lever ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Electronic Throttle Control RelayREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.2. Release the lock and remove the fuse holder from the relay & fuse box.3. Disconnect the connectors from the relay ...