Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed Sensor

REMOVAL

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.

1. Remove the transmission assembly. Automatic Transmission Assembly > REMOVAL">

2. Remove the primary speed sensor.

3. Remove the harness connector from primary speed sensor.

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSTALLATIONCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occur ...

Other materials:

Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyADJUSTMENT1. Remove the liquid gasket from the mating surface completely.2. Using the ST, install the drive pinion retainer to converter case.ST 18270KA020SOCKET (E20)NOTE:Do not confuse the three different-length bolts whe ...

Removal
CLUTCH SYSTEM > FlywheelREMOVAL1. Remove the transmission assembly. Manual Transmission Assembly > REMOVAL">2. Remove the clutch cover and clutch disc. Clutch Disc and Cover > REMOVAL">3. Attach the ST.ST 498497100CRANKSHAFT STOPPER(A)Flywheel4. Remove the flywheel and ...

Dtc p050a cold start idle control system performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P050A COLD START IDLE CONTROL SYSTEM PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine keeps running at higher speed than specified ...

© 2016-2022 Copyright www.sucross.com