Subaru Crosstrek Service Manual: Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump
REMOVAL
1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">
2. Remove the torque converter assembly. Torque Converter Assembly > REMOVAL">
3. Remove the oil pump chain cover. Oil Pump Chain > REMOVAL">
4. Remove the oil pump and the plate.
5. Remove the O-ring.
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil PumpINSPECTIONCheck the following items.• Check the oil pump for damage and wear.• Rotate the oil pump by hand, and check that it rotates ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil PumpINSTALLATION1. Install the O-ring.NOTE:• Use new O-rings.• Apply CVTF to the O-ring.2. Install the plate and the oil pump.NOTE:Apply ...
Other materials:
Dtc u0416 invalid data received from vehicle dynamics control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULEReceived error data from VDC CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROC ...
Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorDISASSEMBLY1. Disconnect the drain tube (A) from the leak check valve assembly.NOTE:Disconnect the quick connector as shown in the figure.2. Lift up the claw (B) of the drain separator and slide the drain separator in the dir ...
Inspection
VEHICLE DYNAMICS CONTROL (VDC) > Yaw Rate and G SensorINSPECTION1. YAW RATE & LONGITUDINAL G AND LATERAL G SENSOR SIGNALSTEPCHECKYESNO1.CHECK YAW RATE & G SENSOR.1) Check the installation condition of the VDC control module & hydraulic control module (VDCCM&H/U).2) Using the Subar ...
