CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor Switch
REMOVAL
1. Shift the select lever to “N” range.
2. Disconnect the ground cable from battery. NOTE">
NOTE:
For model with battery sensor, disconnect the ground terminal from battery sensor.
3. Lift up the vehicle.
4. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">
5. Remove the snap pin and washer from the shifter arm.
CAUTION:
Do not apply extra overload while holding the part (A).
(A) | Shifter arm |
(B) | Snap pin |
(C) | Select cable |
(D) | Washer |
6. Remove the spring pin and shifter arm.
(A) | Spring pin |
(B) | Shifter arm |
7. Remove the inhibitor harness connector from inhibitor switch.
8. Remove the two inhibitor switch securing bolts.
9. Remove the inhibitor switch from the transmission case.
Installation
FRONT SUSPENSION > Front ArmINSTALLATION1. Before installation, inspect the following items and replace any faulty part with a new one.• Check the front arm assembly for damage or cracks, and replace if defective.• Visually check the bushing for abnormal cracks, fatigue or damage.&bul ...
Removal
MECHANICAL(H4DO) > Cam SprocketREMOVAL1. CAM SPROCKET RHNOTE:When replacing a single part, perform the work with the engine assembly installed to body.• Intake cam sprocket RH1. Remove the chain cover. Chain Cover > REMOVAL">2. Remove the timing chain RH. Timing Chain Assembly ...
Dtc c2421 transmitter 1 battery voltage low
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2421 TRANSMITTER 1 BATTERY VOLTAGE LOWNOTE:Refer to DTC C2424 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2424 TRANSMITTER 4 BATTERY VOLTAGE ...