Subaru Crosstrek Service Manual: Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch Assembly
REMOVAL
1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">
2. Remove the air breather hose. Air Breather Hose > REMOVAL">
3. Remove the control valve body. Control Valve Body > REMOVAL">
4. Remove the transmission harness. Transmission Harness > REMOVAL">
5. Remove the turbine speed sensor. Turbine Speed Sensor > REMOVAL">
6. Remove the secondary speed sensor. Secondary Speed Sensor > REMOVAL">
7. Remove the primary speed sensor. Primary Speed Sensor > REMOVAL">
8. Remove the inhibitor switch. Inhibitor Switch > REMOVAL">
9. Remove the extension case. Extension Case > REMOVAL">
10. Remove the transfer clutch assembly. Transfer Clutch > REMOVAL">
11. Remove the transfer driven gear assembly. Transfer Driven Gear > REMOVAL">
12. Remove the parking pawl. Parking Pawl > REMOVAL">
13. Remove the reduction driven gear assembly. Reduction Driven Gear > REMOVAL">
14. Remove the oil pan and oil strainer. Oil Pan and Strainer > REMOVAL">
15. Remove the transmission control device. Transmission Control Device > REMOVAL">
16. Remove the transmission case. Transmission Case > REMOVAL">
17. Remove the reduction drive gear. Reduction Drive Gear > REMOVAL">
18. Remove the primary pulley, secondary pulley and variator chain. Primary Pulley and Secondary Pulley > REMOVAL">
19. Remove the reverse brake assembly. Reverse Brake Assembly > REMOVAL">
20. Remove the internal gear.
21. Remove the thrust bearing.
22. Remove the planetary carrier.
23. Remove the thrust bearing and sun gear.
24. Remove the forward clutch assembly.
25. Remove the thrust bearing and seal ring.
(A) | Thrust bearing |
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyADJUSTMENT1. Install the thrust bearing to the internal gear.NOTE:Face the temper color surface to the reverse brake side.2. Measu ...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyASSEMBLY1. FORWARD CLUTCH ASSEMBLY1. Install the forward clutch piston to forward clutch drum.NOTE:• Apply CVTF to the seal ...
Other materials:
Component
DRIVE SHAFT SYSTEM > General DescriptionCOMPONENT1. PROPELLER SHAFT(1)Propeller shaft(3)Rear differential (T-type)Tightening torque: N·m (kgf-m, ft-lb)(2)Rear differential (VA1-type) T1:31 (3.2, 22.9) T2:52 (5.3, 38.4)2. FRONT AXLE• EBJ + PTJ type(1)Circlip(8)Boot (PTJ)(15)Front ...
Dtc p1449 evap system clog detected (air filter)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1449 EVAP SYSTEM CLOG DETECTED (AIR FILTER)DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode C ...
Maintenance precautions
When maintenance and service are required,
it is recommended that all work be
done by an authorized SUBARU dealer.
If you perform maintenance and service
by yourself, you should familiarize yourself
with the information provided in this
section on general maintenance and
service for your SU ...
