Subaru Crosstrek Service Manual: Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Filter
REMOVAL
NOTE:
• Although CVTF filter is a maintenance-free part, replace it if a large quantity of wear debris and metal particles are found in CVTF and CVTF filter.
• For removal of CVTF filter, refer to “Transmission Case”. Transmission Case > REMOVAL">
Transmission Case > DISASSEMBLY">
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF FilterINSPECTION• Check if a large quantity of wear debris or metal particles are in CVTF and CVTF filter.• Check for broken part or dam ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF FilterINSTALLATIONNOTE:For installation of CVTF filter, refer to “Transmission Case”. Transmission Case > ASSEMBLY"> Transm ...
Other materials:
Activating and deactivating the alarm system
To change the setting of your vehicle's
alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to
"Disarming the system" 2-30.
2. Sit in the driver's seat and shut all
doors and the rear gate.
3. Turn the ignition switch to the "ON"
position.
...
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...
Dtc u0073 control module communication bus off
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&qu ...
