COMMUNICATION SYSTEM > Horn
REMOVAL
CAUTION:
Do not remove the bumper face - front when removing the horn, in order to prevent damaging the claws of the bracket - front bumper corner and the bracket - front bumper side.
1. Disconnect the ground cable from battery. NOTE">
2. Remove the clip, and remove the bracket - grille.
3. Remove the horn assembly - Lo.
(1) Disconnect the connector.
(2) Remove the horn bracket mounting bolt, and remove the horn assembly - Lo.
4. Remove the horn assembly - Hi.
(1) Remove the screw and clips, and turn over the front side of the mud guard - front.
(2) Disconnect the horn connector.
(3) Remove the horn bracket mounting bolt, and remove the horn assembly - Hi.
CAUTION:
The resistor may become hot. Be careful not to burn yourself.
Basic diagnostic procedure Procedure
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the condition of how the trouble occurred. Check List for Interview > CHECK">Did you interview the cust ...
Inspection
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSPECTIONCheck the removed parts for damage, wear, corrosion etc. Repair or replace if defective.• DOJ (Double Offset Joint):Check for seizure, corrosion, damage, wear and excessive play.• BJ (Bell Joint):Check for seizure, corrosion, damage and e ...
Anti-entrapment function
CAUTION
Never attempt to test this function
using fingers, hands or other
parts of your body.
The anti-entrapment function
may not operate properly if some
object gets trapped just before
the window fully closes.
NOTE
If a window detects an impact similar
to that caused by t ...