Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

CLUTCH SYSTEM > Flywheel

REMOVAL

1. Remove the transmission assembly. Manual Transmission Assembly > REMOVAL">

2. Remove the clutch cover and clutch disc. Clutch Disc and Cover > REMOVAL">

3. Attach the ST.

ST 498497100CRANKSHAFT STOPPER

(A)

Flywheel

4. Remove the flywheel and crankshaft position sensor plate.

5. Drive out the pilot bearing from flywheel.

Inspection
CLUTCH SYSTEM > FlywheelINSPECTIONCAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectivene ...

Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the ...

Other materials:

Dtc u0424 invalid data received from hvac control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0424 INVALID DATA RECEIVED FROM HVAC CONTROL MODULEDTC DETECTING CONDITION:Defective data was transmitted from A/C control panel.TROUBLE SYMPTOM:Cooperation control of air conditioner does not operate properly. ...

Occupant detection system
The occupant detection system sensor is installed under the seat upholstery and monitors the physique and posture of the front passenger. Using this information, the occupant detection system determines whether the front passenger's SRS frontal airbag should be deployed or not. If the front ...

Installation
IGNITION(H4DO) > Spark PlugINSTALLATION1. RH SIDEInstall in the reverse order of removal.CAUTION:Degrease the ignition coil installation portion and the mounting bolts.Tightening torque:Spark plug17.5 N·m (1.8 kgf-m, 12.9 ft-lb)Ignition coil8.5 N·m (0.9 kgf-m, 6.3 ft-lb)2. LH SIDEIn ...

© 2016-2025 Copyright www.sucross.com