Subaru Crosstrek Service Manual: Removal
CLUTCH SYSTEM > Clutch Switch
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">
4. Remove the knee airbag module. Knee Airbag Module > REMOVAL">
5. Disconnect the connectors of the clutch switch and clutch start switch.
6. Remove the clutch switch and clutch start switch.
Adjustment
CLUTCH SYSTEM > Clutch SwitchADJUSTMENT1. Loosen the lock nut of the clutch start switch.(A)Lock nut(B)Clutch start switch2. Disconnect the harness connector of the clutch start switch.3. Remove th ...
Inspection
CLUTCH SYSTEM > Clutch SwitchINSPECTION1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clut ...
Other materials:
Dtc u0122 lost communication with vehicle dynamics control module
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data from VDC does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedu ...
Dtc c1251 wheel speed sensor system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1251 WHEEL SPEED SENSOR SYSTEMNOTE:For the diagnostic procedure, refer to “DTC C1241 REAR LEFT ABS SENSOR CIRCUIT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
Dtc b2788 ign signal correlation (steering lock cm)
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2788 IGN SIGNAL CORRELATION (STEERING LOCK CM)DTC detecting condition:When mismatch occurs in the IG1 input of the steering lock CM for both LIN communication line input (IG1 i ...
