CLUTCH SYSTEM > Clutch Pedal
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the steering column. Steering Column > REMOVAL">
4. Disconnect the connector from the stop light switch and clutch switch.
5. Remove the snap pins from clevis pins which secure the lever to the push rod and operating rod.
6. Pull out the clevis pins which secures the lever to the push rod and operating rod.

(A) | Operating rod |
(B) | Push rod |
(C) | Snap pin |
(D) | Clevis pin |
7. Remove the clip (A) from the air intake boot.
8. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).
9. Loosen the clamp (C) which connects the air intake boot and throttle body.

10. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.

11. Remove the nut which secures the clutch master cylinder.
NOTE:
• Remove the master cylinder from the stud bolt.
• Hold the clutch pipe with a wire or a string to avoid the pipe from bending.

12. Remove the bolts and nuts which secure the brake pedal and clutch pedal, and remove the pedal assembly.
Adjustment
AssemblyInstallation of child restraint systems by use of lower and tether
anchorages (LATCH)
WARNING
Child restraint systems and seatbelts
can become hot in a vehicle
that has been closed up in sunny
weather; they could burn a small
child. Check the child restraint
system before you place a child
in it.
Do not leave an unsecured child
restraint system in your vehicle.
...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Hose and PipeREMOVAL1. LOW-PRESSURE HOSE1. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">2. Remove the air intake boot. Air Intake Boot > REMOVAL">CAUTION:Move aside the ...
Dtc p0068 map/maf - throttle position correlation
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0068 MAP/MAF - THROTTLE POSITION CORRELATIONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...