Subaru Crosstrek Service Manual: Removal
BRAKE > Rear Disc Rotor
REMOVAL
1. Lift up the vehicle, and then remove the rear wheels.
2. Release the lever assembly - hand brake.
3. Remove the caliper body assembly from the housing assembly - rear axle.
(1) Remove the bolt from the brake hose bracket.
(2) Remove the mounting bolt, and remove the caliper body assembly.
(3) Prepare wiring harnesses etc. to be discarded, and suspend the caliper body assembly from the shock absorber assembly - rear with the harnesses.
4. Remove the rear disc rotor.
NOTE:
If it is difficult to remove the disc rotor, perform the following two methods in order.
(1) Remove the adjusting hole cover (A), and loosen the adjuster assembly - rear brake by inserting a flat tip screwdriver.
(a) | Adjuster ASSY - rear brake | (c) | Disc rotor | (e) | Shorten the adjuster ASSY - rear brake |
(b) | Flat tip screwdriver | (d) | Extend the adjuster ASSY - rear brake |
(2) When the disc rotor is difficult to be removed from the hub unit COMPL - rear axle, screw in 8 mm (0.31 in) bolt to the threaded part of the disc rotor (A), and remove the disc rotor.
Inspection
BRAKE > Rear Disc RotorINSPECTION1. DISC ROTOR RUNOUT CHECK1. Check the hub unit COMPL - rear axle for free play and runout before the inspection of disc rotor runout limit. Rear Hub Unit Bearing ...
Installation
BRAKE > Rear Disc RotorINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly.1. Before installation, check the rear disc rotor. Rear Disc Rotor > IN ...
Other materials:
Fuel consumption screen setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
" or "
" switch to
select the "Cons" item. Then push the
button.
3. Push the
button once more.
4. Select the displayed configuration by
operating the "
" or ...
Lock/unlock
The rear gate can be locked and unlocked
using any of the following systems
Power door locking switch: Refer to
"Power door locking switches" 2-8.
Keyless access with the push-button
start system (if equipped): Refer to "Keyless
access with push-button start system"
2-9.
...
Dtc u0155 lost communication with instrument panel cluster (ipc) control module
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULENOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunctio ...
