Subaru Crosstrek Service Manual: Removal
BRAKE > Rear Brake Pad
REMOVAL
1. Lift up the vehicle, and then remove the rear wheels.
2. Remove the rear brake pad.
(1) Remove the bolts and remove the brake hose bracket.
(2) Remove the caliper bolt, and raise and hold the caliper body assembly.
NOTE:
Do not disconnect the brake hose from the caliper body assembly.
(3) Remove the brake pad from support - rear disc brake.
Inspection
BRAKE > Rear Brake PadINSPECTION1. Check the pad thickness.NOTE:• Always replace the pads of both wheels and both sides as a set.• Replace pad clips if they are twisted or worn.• ...
Installation
BRAKE > Rear Brake PadINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly and support - rear disc brake.1. Before installation, check the brake pad. ...
Other materials:
Front passenger's frontal airbag ON and OFF indicators
Front
passenger's frontal airbag ON
indicator
Front
passenger's frontal airbag OFF
indicator
The front passenger's frontal airbag ON
and OFF indicators show you the status of
the front passenger's SRS frontal airbag.
The indicators are located next to the
clock in the center po ...
Selecting an audio source
1. Press the AUDIO/TUNE knob.
2. Select the desired source.
Example: Source select screen
NOTE
If the audio control screen appears,
select the "Source" key on the audio
screen or press the AUDIO/TUNE knob
again.
When you push the AUDIO/TUNE
knob while any screen other than t ...
Caution
EyeSight (DIAGNOSTICS) > General DescriptionCAUTION1. AIRBAG SYSTEMAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage t ...
