Subaru Crosstrek Service Manual: Removal
BRAKE > Front Disc Brake Assembly
REMOVAL
CAUTION:
Do not allow brake fluid to come in contact with the painted surface of the vehicle body. If it does, wash off with water and wipe away completely.
1. Lift up the vehicle, and then remove the front wheels.
2. Remove the caliper body assembly.
(1) Remove the union bolt and caliper bolt, and remove the caliper body assembly from the support - front disc brake.
3. Remove the support - front disc brake.
NOTE:
Remove the support - front disc brake only when replacing the disc rotor or the support - front disc brake. It is not necessary to remove it when servicing the caliper body assembly.
(1) Remove the brake pad from support - front disc brake.
(2) Remove the mounting bolts, and then remove the support - front disc brake from the housing assembly - front axle.
Assembly
BRAKE > Front Disc Brake AssemblyASSEMBLY1. Before assembly, check each part. Front Disc Brake Assembly > INSPECTION">2. Clean the inside of the caliper body cylinder using brake fluid. ...
Disassembly
BRAKE > Front Disc Brake AssemblyDISASSEMBLYCAUTION:Be careful not to allow foreign matter to enter the brake hose connector.1. Remove mud and foreign matter from the caliper body.2. Remove the pis ...
Other materials:
Phone volume settings
The call and ringtone volume can be
adjusted. A ringtone can be selected.
1. Display the "PHONE" screen. Refer to
"How to change the hands-free phone
system" F5-73.
2. Touch the key.
3. Select the desired item to be set.
On the "PHONE" screen, the screen
changes to the "Options" s ...
Operation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof Control SystemOPERATION1. INITIALIZE OPERATIONCAUTION:During initialization, perform the position learning and the sliding learning. Sliding learning mode can not be initiated unless the position learning is performed.NOTE:When initialize operatio ...
Removal
INTAKE (INDUCTION)(H4DO) > Air Cleaner ElementREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B). ...
