Subaru Crosstrek Service Manual: Removal

Subaru Crosstrek Service Manual / Brake / Brake pipe / Removal

BRAKE > Brake Pipe

REMOVAL

CAUTION:

• Be careful of the following items. Failure to do so may cause the airbag system malfunction.

– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION">

– Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.

• Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.

• When removing the brake pipe, do not bend.

NOTE:

The airbag system wiring harness is routed near the center brake pipe.

Inspection

BRAKE > Brake PipeINSPECTIONCheck the pipe for crack and damage, and also check the connection for fluid leakage. If any faulty is found, repair or replace the relevant part.NOTE:Use a mirror when ...

Installation

BRAKE > Brake PipeINSTALLATIONCAUTION:• Be careful of the following items. Failure to do so may cause the airbag system malfunction.– Yellow connectors and harnesses with yellow tapes arou ...

Other materials:

Front seatbelts
1. Adjust the seat position according to the following procedure. Driver's seat: Adjust the seatback to the upright position. Move the seat as far from the steering wheel as practical while still maintaining full vehicle control. Front passenger's seat: Adjust the seatback to the upright ...

Hill start assist warning light/Hill start assist OFF indicator light
Hill start assist warning light While the engine is running, if there are any malfunctions in the Hill start assist system, the warning light will illuminate. WARNING When the Hill start assist warning light illuminates, have the vehicle inspected at an authorized SUBARU dealer. Hill st ...

Removal
FRONT SUSPENSION > Front StrutREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the front strut assembly.(1) Place an alignment mark (a) on the adjusting bolt and the strut.(2) Remove the brake hose bracket.(3) Remove the clamp of ABS wheel speed sensor harness.(4) Remove ...