BRAKE > Brake Hose
REMOVAL
1. FRONT BRAKE HOSE
1. Disconnect the brake pipe (b) from the brake hose (a).
Preparation tool:
Flare nut wrench
2. Remove the clamp, strut mounting bolt and union bolt, and remove the front brake hose.
2. REAR BRAKE HOSE
1. Remove the brake hose bracket bolt and union bolt.
2. Disconnect the brake pipe (a).
Preparation tool:
Flare nut wrench
3. Remove the brake hose clamp (b), and remove the rear brake hose (c).
General diagnostic table Inspection
CONTROL SYSTEMS > General Diagnostic TableINSPECTIONSymptomsPossible causeCorrective actionSelect leverStarter does not run.Adjust the select cable and inhibitor switch, or inspect the circuit.Back-up light does not illuminate.Adjust the select cable and inhibitor switch, or inspect the circuit.A ...
Disassembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the front hub unit bearing (a).CAUTION:• Be careful not to hammer the hub bolts. This may deform the hub unit bearing.• Do not reuse the hub bolt.NOTE:Since the hub ...
ECO gauge (if equipped)
U.S.-spec. models
Except U.S.-spec. models
The ECO gauge shows the difference
between the current rate of fuel consumption
and the average rate of fuel consumption
since the trip meter was last reset.
If the needle of the gauge moves towards
the right side, this indicates better f ...