Subaru Crosstrek Service Manual: Release bearing and lever

Installation

CLUTCH SYSTEM > Operating CylinderINSTALLATION1. Install in the reverse order of removal.NOTE:• Before installing the operating cylinder, apply grease to the contact point of the release leve ...

Inspection

CLUTCH SYSTEM > Release Bearing and LeverINSPECTION1. RELEASE BEARINGCAUTION:Since this bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or any other solvent when s ...

Other materials:

Dtc b1633 curtain airbag sensor rh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1633 CURTAIN AIRBAG SENSOR RH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (RH)• Side airbag sensor (RH) ...

SRS airbag system warning light
WARNING If the warning light exhibits any of the following conditions, there may be a malfunction in the seatbelt pretensioners and/or SRS airbag system. Immediately take your vehicle to your nearest SUBARU dealer to have the system checked. Unless checked and properly repaired, the seatb ...

Assembly
REAR SUSPENSION > Rear Shock AbsorberASSEMBLY1. Before assembly, check each part. Rear Shock Absorber > INSPECTION">2. Using a coil spring compressor, compress the coil spring - rear.CAUTION:When installing the coil spring compressor to the coil spring, follow the operation manual acc ...