Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Relay and fuse

Inspection

CRUISE CONTROL SYSTEM > Relay and Fuse

INSPECTION

1. CHECK FUSE

1. Remove the fuse and inspect visually.

2. If the fuse is blown out, replace the fuse.

NOTE:

If the fuse is blown again, check the system wiring harness.

Location

CRUISE CONTROL SYSTEM > Relay and Fuse

LOCATION

Relay & fuse box

Fuse 10 A (stop light & brake switch)

(A)

NOTE:

For other related fuses, refer to the wiring diagram. Power Supply Circuit">

General description
Caution CRUISE CONTROL SYSTEM > General DescriptionCAUTION• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, con ...

Cruise control command switch
Installation CRUISE CONTROL SYSTEM > Cruise Control Command SwitchINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Descrip ...

Other materials:

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Oil Temperature SensorINSPECTION1. Check that the engine oil temperature sensor has no deformation, cracks or other damages.2. Immerse the engine oil temperature sensor and a thermometer in water.CAUTION:Take care not to allow water to get into the eng ...

Installation
BRAKE > Stop Light SwitchINSTALLATION1. BULB TYPE1. Install the stop light switch.CAUTION:• Turn the stop light switch clockwise when installing so that it can return backward by approximately 1 mm (0.04 in) and clearance is automatically adjusted.• If it is hard to turn the switch, r ...

Unlocking
Perform steps 1 to 5 described in "Registration". NOTE You cannot unlock by PIN Code Access in the following cases. when the access key is within the operating ranges when the ignition switch is in the "ACC" or "ON" position If you make an operation error during the unlocking proced ...

© 2016-2022 Copyright www.sucross.com