Blind Spot Detection/Rear Cross Traffic Alert > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
NOTE:
If the fuse is blown again, check the system wiring harness.
Blind Spot Detection/Rear Cross Traffic Alert > Relay and Fuse
LOCATION

Fuse & Relay Box | Fuse 10 A (radar sensor LH (master), radar sensor RH (slave), BSD/RCTA OFF switch) | (A) |
NOTE:
For other related fuses, refer to the wiring diagram. Power Supply Circuit">
Radar sensor
Switches and harnessDtc b1574 key communication
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1574 KEY COMMUNICATIONDTC DETECTING CONDITION:Communication failure between key and body integrated unitCAUTION:When the body integrated unit is replaced, registration of the immobilizer system is required. Fo ...
Battery drainage prevention function
If a door or the rear gate is not completely
closed, the interior lights will remain
illuminated as a result. However, several
lights are automatically turned off by the
battery drainage prevention function to
prevent the battery from discharging. The
following interior lights are affected by ...
Fuel consumption screen setting
1. Perform the preparation steps according
to "Preparation for screen settings"
2. Operate the "
" or "
" switch to
select the "Cons" item. Then push the
button.
3. Push the
button once more.
4. Select the displayed configuration by
operating the "
" or ...