Subaru Crosstrek Owners Manual: Registering a Bluetooth Audio device for the first time
To use the Bluetooth Audio, it is necessary to register an audio device with the system.
The device registration procedure is the same for both the hands-free system and Bluetooth audio.
1. Display the "BT Devices Connection" screen. Refer to "Registering a Bluetooth phone for the first time" F5-65.
2. Select the "Add" key.
The "Add" key is not displayed when five devices are already registered.
To add another device, you need to delete one of the registered devices.
Press the 
key for the device to be
deleted, and then select the "OK" key.
3. Register the Bluetooth device using your Bluetooth device.
- A PIN-code is not required for SSP (Secure Simple Pairing) compatible Bluetooth devices. Depending on the type of Bluetooth device being connected, a message confirming registration may be displayed on the Bluetooth device's screen. Respond and operate the Bluetooth device according to the confirmation message.
4. Check that the screen is displayed when registration is complete.
- The system waits for connection requests coming from the registered device.
- At this stage, the Bluetooth functions are not yet available.
Registering a Bluetooth phone for
the first time
To use the hands-free system, it is
necessary to register a Bluetooth phone
with the system.
For details about registering a Bluetooth
device: Refer to "Registering a Bluetooth
Audio device for ...
Profiles
This system supports the following services.
NOTE
If your cell phone does not support HFP, registering the Bluetooth
phone or using OPP, PBAP, or SPP profiles individually
will not be poss ...
Other materials:
Dtc p0451 evap system (cpc) pressure sensor/switch circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0451 EVAP SYSTEM (CPC) PRESSURE SENSOR/SWITCH CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, ...
Low tire pressure warning light (U.S.-spec. models)
When
the ignition switch is turned to the
"ON" position, the low tire pressure warning
light will illuminate for approximately 2
seconds to check that the tire pressure
monitoring system (TPMS) is functioning
properly. If there is no problem and all tires
are properly inflated, the light w ...
Contrast setting
1. Perform the preparation steps according
to "Preparation for image quality and
volume settings"
2. Operate the "
" or ""
switch to
select the "Contrast" item. Then push the
button.
3. Select a contrast level by operating the
"
"
or "
" switch, and confirm the setting
b ...
