HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Recovery Procedure
PROCEDURE
CAUTION:
• During operation, be sure to wear protective goggles and protective gloves.
• Connect the refrigerant recovery system with the manifold gauge set to discharge the refrigerant from the A/C system and recycle the gas.
• When recycling the discharged refrigerant, keep service cans on hand. Because the recovery rate with the recovery system is approx. 90%, service cans are necessary to charge the refrigerant.
• Follow the detailed operation procedure described in the operation manual attached to the refrigerant recovery system.
(1) | Manifold gauge | (4) | High pressure valve | (7) | High-pressure hose |
(2) | Low pressure valve | (5) | Low-pressure hose | (8) | Low-pressure side service port |
(3) | Center valve | (6) | Center manifold hose (vacuum pump and charge) | (9) | High-pressure side service port |
1. Perform compressor oil return operation. Compressor Oil > PROCEDURE">
2. Turn the ignition switch to OFF.
3. Attach the manifold gauge set.
Preparation tool:
Manifold gauge set
(1) Check that all valves are fully closed.
(2) Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle respectively.
CAUTION:
Confirm that the connections are secure.
(3) Connect the center hose to the refrigerant recovery system.
Preparation tool:
Refrigerant recovery system
4. Follow the operation manual attached to the refrigerant recovery system to collect the refrigerant.
Inspection
MECHANICAL(H4DO) > Cam ClearanceINSPECTION1. WHEN TIMING CHAIN ASSEMBLY IS NOT REMOVEDCAUTION:When working on the vehicle, if engine oil is spilt onto the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.NOTE:• Inspection of cam clearance should be performed ...
Operation
GLASS/WINDOWS/MIRRORS > Power Window SystemOPERATION1. RESET OPERATION A1. Sit in the driver’s seat and close the door.2. Turn the ignition switch to ON.3. Operate the switch - power window main to open the glass assembly - front door halfway.4. Operate the switch - power window main in &ld ...
Removal
CRUISE CONTROL SYSTEM > Cruise Control Command SwitchREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Set the tire to the straight-ahead po ...