Subaru Crosstrek Owners Manual: Rear windows side seating position
- Head restraint
- Release button
To remove: While pressing the release button, pull out the head restraint.
To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. Press and hold the release button to lower the head restraint.
After installing the head restraint, make sure it is securely locked.
Head restraint adjustment
Both the rear window side seats and the
rear center seat are equipped with head
restraints.
WARNING
Never drive the vehicle with the
head restraints removed because
they are designed to red ...
Rear center seating position
CAUTION
The head restraint is not intended to
be used at the retracted position.
Before sitting on the seat, raise the
head restraint to the extended position.
Incorrect (retracted posit ...
Other materials:
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel FilterINSTALLATION1. Install O-ring (A), O-ring (B), and backup ring (C) to the pressure regulator.NOTE:• Use new O-rings.• Apply gasoline to the O-ring and backup ring.2. Install the pressure regulator to the fuel filter assembly.3. Install ...
Dtc p015a a/f / o2 sensor delayed response - rich to lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P015A A/F / O2 SENSOR DELAYED RESPONSE - RICH TO LEAN BANK 1 SENSOR 1NOTE:For the diagnostic procedure, refer to DTC P014C. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P014C A/F / O2 SENS ...
Assembly
FRONT SUSPENSION > Front ArmASSEMBLY1. BUSHING FRONT - FRONT ARM1. Before assembly, inspect the following items and replace any faulty part with a new one.• Check the front arm assembly for damage or cracks, and replace if defective.• Visually check the bushing for abnormal cracks, fa ...
