Subaru Crosstrek Service Manual: Rear washer

Preparation tool

WIPER AND WASHER SYSTEMS > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooti ...

Inspection

WIPER AND WASHER SYSTEMS > Rear WasherINSPECTION1. VISUAL INSPECTIONCheck for the following items, and if any malfunction is found, replace the corresponding part.• Make sure the nozzle - rea ...

Other materials:

Dtc p2270 o2 sensor signal biased/stuck lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2270 O2 SENSOR SIGNAL BIASED/STUCK LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...

Dtc c1412 selected parameter
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1412 SELECTED PARAMETERDTC DETECTING CONDITION:VDCCM parameter selection errorTROUBLE SYMPTOM:• ABS does not operate.• EBD does not operate.• VDC does not operate.• H ...

System temporary stop indicator
System temporary stop indicator This indicator appears when the system is used under the following conditions. Extremely high or low temperatures When abnormal voltage exists for the vehicle battery When the radar sensor is significantly misaligned Once the above conditions are ...