Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Rear towing hook

1. Take the towing hook and screwdriver out of the tool bucket. Take the jack handle out of the cargo area.

Rear towing hook

2. Pry off the cover on the rear bumper using a screwdriver, and you will find a threaded hole for attaching the towing hook.

Rear towing hook

3. Screw the towing hook into the thread hole until its thread can no longer be seen.

Rear towing hook

4. Tighten the towing hook securely using the jack handle.

After towing, remove the towing hook from the vehicle and stow it in the tool bucket.

Fit the towing hook cover on the bumper.

WARNING

Front tie-down hooks

Front tie-down hooks

The front tie-down hooks are located between each of the front tires and the front bumper.

Front towing hook
1. Take the towing hook and screwdriver out of the tool bucket. Take the jack handle out of the cargo area. 2. Cover the tip of a flat-head screwdriver with vinyl tape or cloth so that it will ...

Rear tie-down holes
Rear tie-down hole The rear tie-down holes are located near each of the jack-up reinforcements. There is a plug in each rear tie-down hole. To use the rear tie-down holes, remove the ...

Other materials:

System temporary stop indicator
System temporary stop indicator This indicator appears when the system is used under the following conditions. Extremely high or low temperatures When abnormal voltage exists for the vehicle battery When the radar sensor is significantly misaligned Once the above conditions are ...

Engine trouble in general Inspection
MECHANICAL(H4DO) > Engine Trouble in GeneralINSPECTIONNOTE:The “RANK” shown in the chart shows the possibilities of the cause of trouble in order from “Very often” to “Rarely”.A — Very oftenB — SometimesC — RarelySymptomsProblem parts etc.Possible causeRA ...

Dtc b2788 ign signal correlation (steering lock cm)
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2788 IGN SIGNAL CORRELATION (STEERING LOCK CM)DTC detecting condition:When mismatch occurs in the IG1 input of the steering lock CM for both LIN communication line input (IG1 i ...

© 2016-2026 Copyright www.sucross.com