Subaru Crosstrek Service Manual: Rear gate garnish

Subaru Crosstrek Service Manual / Exterior/interior trim / Rear gate garnish

Removal

EXTERIOR/INTERIOR TRIM > Rear BumperREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to da ...

EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the rever ...

Other materials:

Keyless access system check Operation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Keyless Access System CheckOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve ActuatorREMOVAL1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from tumble generator valve assembly, and remove the tumble generator valve actuator.• RH side• LH side ...

Installation
EXHAUST(H4DO) > Rear Exhaust PipeINSTALLATION1. Apply a coat of spray type lubricant to the mating area of cushion rubber.2. Install the rear exhaust pipe to cushion rubber.NOTE:After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.3. Install t ...