Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Rear drive shaft

Installation
DRIVE SHAFT SYSTEM > Rear AxleINSTALLATION1. Temporarily tighten the rear axle housing to the upper arm assembly.2. Install the rear drive shaft assembly.CAUTION:• Do not hammer the drive sha ...

Assembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftASSEMBLYCAUTION:Wrap shaft splines with vinyl tape to protect the boot from scratches.NOTE:Use specified grease.Grease:BJ, EBJ side: NKG814DOJ side: NKG8141. In ...

Other materials:

New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your vehicle are dependent on how you handle and care for your vehicle while it is new. Follow these instructions during the first 1,000 miles (1,600 km): Do not race the engine. And do not allow engine speed to exceed 4,000 rpm except in an emergency ...

Removal
DRIVE SHAFT SYSTEM > Front Drive ShaftREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle nut ...

Dtc u0423 invalid data received from instrument panel cluster control module
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0423 INVALID DATA RECEIVED FROM INSTRUMENT PANEL CLUSTER CONTROL MODULEFailure counter diagnosis of combination meterNOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...

© 2016-2026 Copyright www.sucross.com