Subaru Crosstrek Service Manual: Rear disc brake assembly

Installation

BRAKE > Rear Brake PadINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly and support - rear disc brake.1. Before installation, check the brake pad. ...

Assembly

BRAKE > Rear Disc Brake AssemblyASSEMBLY1. Before installation, check each part. Rear Disc Brake Assembly > INSPECTION">2. Clean the inside of the caliper body cylinder using brake flui ...

Other materials:

Models with "keyless access with push-button start system"
NOTE For more details, refer to the Owner's Manual supplement for the remote engine start system. Access key Lock button An access key can be used as the remote engine start transmitter. Operate the lock button to start or stop the engine as follows. Before starting the engine Befo ...

32
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code32This DTC is detected out of vehicle speed range.Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.If cancel code is still detected after setting cruise a ...

Installation
COMMUNICATION SYSTEM > HornINSTALLATIONCAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).Install each part in the reverse order of removal.Tightening torque:Horn a ...