CAUTION
The head restraint is not intended to be used at the retracted position.
Before sitting on the seat, raise the head restraint to the extended position.
To raise: Pull the head restraint up.
To lower: Push the head restraint down while pressing the release button on the top of the seatback.
To remove: While pressing the release button, pull out the head restraint.
To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. Press and hold the release button to lower the head restraint.
When the rear-center seating position is occupied, raise the head restraint to the extended position. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility.
Brake line Inspection
PERIODIC MAINTENANCE SERVICES > Brake LineINSPECTION1. BRAKE LINE1. Check for scratches, swelling, corrosion, traces of fluid leakage on the brake hoses or pipe joints.2. Make sure that brake pipes/hoses do not interfere with adjacent parts and there is no loose connector/clamp during driving.3. ...
Dtc b2329 rear radar axis alignment incomplete
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2329 REAR RADAR AXIS ALIGNMENT INCOMPLETEDTC DETECTING CONDITION:Axis adjustment of the radar sensor has failed.(Forced termination of the Subaru Select Monitor, improper loca ...
Replacing transmitter battery
1. Open the key head using a flat-head
screwdriver.
2. Remove the transmitter case from the
key head.
3. Open the transmitter case by releasing
the hooks.
1) Negative (−) side facing up
4. Replace the old battery with a new
battery (type CR1620 or equivalent) making
su ...