Subaru Crosstrek Service Manual: Real-time diagnosis Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Real-time Diagnosis
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Engine Control System» and then «Enter».
5. On «Select Function» display, select «Data Monitor».
6. Make sure that normal display is shown when operated as follows:
• Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.)
• Turn the “CRUISE” switch to ON.
• Turn the “CANCEL” switch to ON.
• Turn the “SET/−” switch to ON.
• Turn the “RES/+” switch to ON.
• Depress or release the clutch switch.
• Place the shift lever in any position other than neutral.
NOTE:
For detailed operation procedures, refer to “Application help”.
Read cancel code Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Read Cancel CodeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «C ...
Subaru select monitor Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. GENERAL DESCRIPTIONThe on-board diagnosis function of the cruise control system uses Subaru Select Monitor.The on-board diagno ...
Other materials:
Removal
ENTERTAINMENT > Rearview Camera SystemREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the arm assembly - rear wiper. Rear Wiper Arm > REMOVAL">4. Remove the motor ...
Fog light switch
Headlight switch
Fog light switch
The front fog lights will turn on when the
fog light switch is placed in the "
"
position while the headlights are in the
following condition.
while the headlight switch is in the "
"
position
for models with the auto on/off h ...
Dtc u0073 control module communication bus off
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
