Subaru Crosstrek Service Manual: Read diagnostic trouble code (dtc) Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Transmission Control System».

5. On «Select Function» display, select «DTC».

NOTE:

• For details concerning the DTC, refer to “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)">

• For detailed operation procedures, refer to “Application help”.

List of diagnostic trouble code (dtc) List

Subaru select monitor Operation

Other materials:

Communication for initializing impossible
LAN SYSTEM (DIAGNOSTICS) > Subaru Select MonitorCOMMUNICATION FOR INITIALIZING IMPOSSIBLEDIAGNOSIS:Subaru Select Monitor communication line is open or shorted.TROUBLE SYMPTOM:Not communicable with Subaru Select Monitor.WIRING DIAGRAM:CAN communication system CAN Communication System > WIRING ...

Installation
CLUTCH SYSTEM > Release Bearing and LeverINSTALLATIONNOTE:Apply the specified grease to lubricate to the following points before installation.• Contact surface of lever and pivot• Contact surface of lever and bearing• Transmission main shaft spline• Contact surface of rele ...

To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET" side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as the new set speed. U.S.-spec. models When the difference between the actual vehicle speed and ...