Subaru Crosstrek Service Manual: Read diagnostic trouble code (dtc) Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Subaru Rear Vehicle Detection(RH)» or «Subaru Rear Vehicle Detection(LH)» and then select «Enter».

5. On «Select Function» display, select «DTC».

NOTE:

• For detailed operation procedures, refer to “Application help”.

• For details concerning DTC, refer to the List of Diagnostic Trouble Codes (DTC). List of Diagnostic Trouble Code (DTC)">

• Check and replace the side that displayed the DTC.

Read cancel code Operation

Blind spot detection/rear cross traffic alert

Other materials:

Hazard warning flasher
The hazard warning flasher in the Subaru Ascent is designed to alert surrounding drivers when the vehicle is stopped under emergency or hazardous conditions, ensuring maximum visibility and safety on the road. The hazard warning system in the Subaru Ascent operates independently of the ig ...

Dtc c0064 normal closing valve 2 malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0064 NORMAL CLOSING VALVE 2 MALFUNCTIONDTC detecting condition:• Defective harness connector• Defective VDCH/U solenoid valveTrouble symptom:• ABS does not operate.• ...

Dtc p0123 throttle/pedal position sensor/switch "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0123 THROTTLE/PEDAL POSITION SENSOR/SWITCH "A" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving per ...