OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Read Current Data
OPERATION
Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch, or when the seat belt buckle switch has been replaced.
NOTE:
For detailed operation procedures, refer to “Application help”.
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Occupant Detection».
5. On «Occupant Detection» display, select «Data Monitor».
The following table is for support data.
Item | Display | Note |
Front Passenger Seat Status | Empty or Child/Adult or Child | “Adult or Child” when the seat is occupied “Empty or Child” when the seat is unoccupied or when child restraint seat is installed CAUTION: |
When checking the operating status, be careful of the followings.
• When the seat is unoccupied: Do not place anything on the seat.
• Child restraint seat: Install the seat according to its instruction manual.
• When the seat is occupied: Someone who weighs at least approx. 70 kg (155 lb) must be seated during the check.
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)INSPECTIONReplace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check that there are no CVTF or engine coolant leaks from the connections.2. Check the clamp for deformation. ...
Dtc p0606 control module processor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0606 CONTROL MODULE PROCESSORDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, p ...
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3. ...