Inspection
OperationInspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSPECTION1. MAGNET CLUTCH CLEARANCE INSPECTION1. Check the clearance of entire circumference around the drive plate and pulley.Specification:0.3 — 0.6 mm (0.0118 — 0.0236 in)2. Replace the compressor assembly if the inspection result is no ...
Removal
LIGHTING SYSTEM > Front Fog Light AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of the mud guard - front.4. From the bottom of the bumper face - front, remove the fog light assembly - f ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSTALLATIONCAUTION:• Replace the O-rings on the hose - pressure suction and discharge with new parts, and then apply compressor oil.• After replacing the compressor assembly, adjust the amount of the compressor oil. Compressor Oil ...