CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Read Cancel Code
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Engine Control System».
5. Drive vehicle at 40 km/h (25 MPH) or more and set the cruise control.
CAUTION:
• When performing diagnosis, observe the legal speed limit on the road.
• The cancel code will also appear when the cruise control is cancelled by the driver’s operation. Do not confuse them.
• Be sure to get an assistant to support the diagnosis while driving, and have him/her operate the select monitor.
6. When the set speed is cancelled by itself (when cancelled without a cancel operation such as applying the brake) or if the cruise control could not be set by performing the setting operation, selecting the «Cancel Code» on the engine malfunction diagnosis screen will display the cancel code on the select monitor display.
NOTE:
The «Current» and «The past» are contained in the cancel code. The latest code recognized during current test drive is displayed in «Current». Cancel codes resulting from fault diagnosis of switches relating to the system and cruise control are also displayed in «The past».
7. Perform Engine DTC Clear Memory operation. Clear Memory Mode > OPERATION">
Cancel codes for switches relating to the system and cruise control are deleted by clearing memory on the engine side.
NOTE:
• The latest code will be cleared by turning ignition switch to OFF.
• For detailed operation procedures, refer to “Application help”.
• For details on cancel codes, refer to List of Cancel Code. List of Cancel Code">
Inspection
BRAKE > Brake BoosterINSPECTION1. OPERATION CHECK WHEN NOT USING MEASURING DEVICESCAUTION:When checking operation, be sure to apply the parking brake securely.When an operation check is performed with no measuring devices, a faulty part cannot be identified correctly. But it is possible to identi ...
Inspection
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly - front.2. LOCK ACTUATORPreparation tool:Circuit tester1. Check door lock operationCheck the door lo ...
Dtc c1251 wheel speed sensor system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1251 WHEEL SPEED SENSOR SYSTEMNOTE:For the diagnostic procedure, refer to “DTC C1241 REAR LEFT ABS SENSOR CIRCUIT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...