Subaru Crosstrek Service Manual: Radiator

Preparation tool

COOLING(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS18355AA000PULLEY WRENCH• Used for removing and installing water pump pulley.• ...

Inspection

COOLING(H4DO) > RadiatorINSPECTION1. Check that the radiator does not have deformation, cracks or damage.2. Check that the hose has no cracks, damage or loose part.3. Remove the radiator cap, fill ...

Other materials:

Installation
SECURITY AND LOCKS > Impact SensorINSTALLATION1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Disconnect the ground cable from battery. NOTE">5. In ...

Handling of radar sensors
Radar sensors The radar sensors, one on each side of the vehicle, are mounted inside the rear bumper. CAUTION To ensure correct operation of the BSD/RCTA, observe the following precautions. Always keep the bumper surface near the radar sensors clean Do not affix any stickers o ...

Removal
LIGHTING SYSTEM > Hazard SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the center grille assembly. Air Vent Grille > REMOVAL">3. Release the claws, and remove the switch - hazard from the center grille assembly. ...