Subaru Crosstrek Service Manual: Procedure

1. METHOD FOR STOPPING KEYLESS ACCESS SYSTEM FUNCTION BY OPENING/CLOSING DOORS

1. Check that the vehicle status is as follows:

• Ignition switch OFF

• One window is completely open

• Keyless access system is activated (or disabled if re-activating)

2. Sit in the driver’s seat with the door closed and press the door lock switch to UNLOCK once.

3. Open the driver’s door within five seconds.

4. Within 5 seconds, with the driver’s door opened, slowly press the door lock switch to UNLOCK twice.

5. Within 10 seconds after finishing step 4), perform the closing > opening operation of the driver’s door twice.

6. Within 10 seconds after finishing step 5), with the driver’s door opened, slowly press the door lock switch to UNLOCK twice.

7. Within 10 seconds after finishing step 6), perform the closing > opening operation of the driver’s door once.

8. Within five seconds after finishing step 7), close the drivers door.

NOTE:

• Perform the same procedures to re-activate the keyless access system from the disabled condition.

• In step 4) and step 6), press the door lock switch completely. The function may not work properly if the switch is pressed shortly.

1. Open the driver’s door and press the door lock knob forward (in the LOCK direction).

2. Press the lock button and the trunk/rear gate button of the access key simultaneously for at least five seconds.

3. A buzzer sounds for two seconds and the function stops.

NOTE:

Perform the same procedures to re-activate the keyless access system from the disabled condition.

Operation

General description

Other materials:

Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyADJUSTMENTSelection of main shaft rear plate:Measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.NOTE:Before measuring, tap the end of main shaft wi ...

Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Universal JointINSTALLATION1. Before installation, check the universal joint assembly - steering. Universal Joint > INSPECTION">2. Adjust the tilt position of the column assembly - steering to the neutral position and lock the tilt lever.3. Ali ...

Dtc u0140 lost communication with body control module
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0140 LOST COMMUNICATION WITH BODY CONTROL MODULEDetected when CAN data from BIU does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...