CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > AWD ON/OFF Switching Mode
PROCEDURE
CAUTION:
• Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.
• On completing the work in FWD, switch back in AWD.
1. Shift the select lever to “P” range.
2. Connect the Subaru Select Monitor to data link connector.
3. Turn the ignition switch to ON.
4. Turn off all switches causing an electrical load, such as headlights, A/C, seat heater and rear defogger.
5. Select «Diagnosis» in the «Start» screen of Subaru Select Monitor.
6. On «Vehicle selection» display, input the vehicle information and select «Confirmed».
7. On «Main Menu» display, select «Each System».
8. On «Select System» display, select «Transmission Control System».
9. On «Select Function» display, select «Work Support».
10. Select «AWD ON/OFF switching mode» in the «Work Support» screen.
11. Follow the messages displayed on the Subaru Select Monitor screen when working.
Switching completes successfully if any of the following messages is displayed.
• When switching from AWD to FWD: «Switched to FF. To return to AWD, perform basic mode again.»
• When switching from FWD to AWD: «Switched to AWD. To return to FF, perform basic mode again.»
NOTE:
• If communication error occurs during switching mode, start in the «AWD ON/OFF switching mode» again.
• If operation is interrupted before the successful end message is displayed, perform the «AWD ON/OFF switching mode» from the beginning until confirming the operation is successfully ended. If this mode fails to complete successfully, the cause is as follows.
• Select lever is not in “P” range.
• Engine is running.
• For detailed operation procedures, refer to “Application help”.
ABS (Anti-lock Brake System)
The ABS prevents the lock-up of wheels
which may occur during sudden braking or
braking on slippery road surfaces. This
helps prevent the loss of steering control
and directional stability caused by wheel
lock-up.
When the ABS is operating, you may hear
a chattering noise or feel a slight v ...
Installation
SECURITY AND LOCKS > Front Hood Lock AssemblyINSTALLATION1. Before installation, check the following items.• Is the cable deformed?• Grease is applied sufficiently to cable joints.If grease is insufficient, add it as necessary before assembling the cable.2. Install each part in the re ...
Road test Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Road TestINSPECTION1. GENERAL PRECAUTIONRoad tests should be conducted to properly diagnose the condition of CVT.CAUTION:Always observe the local traffic laws when performing the test.2. D RANGE SHIFT FUNCTIONMake sure that the engine speed is 1,100 — ...