Installation
InspectionDoor unlock selection function
The door unlock selection function makes
the following operations possible.
Unlocking the driver's door without
unlocking any other doors (including the
rear gate) when gripping the driver's door
handle
Opening the rear gate without unlocking
any doors when pressing the rear gate
op ...
Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...
Relay and fuse
Inspection
CRUISE CONTROL SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness. Location
CRUISE CONTROL SYSTEM > Relay and FuseLOCATIONRelay & f ...