Subaru Crosstrek Service Manual: Preparation tool
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Circuit tester | Used for measuring resistance, voltage and current. |
DST-i | Used together with Subaru Select Monitor 4. |
Caution
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > General DescriptionCAUTION1. BSD/RCTA(1) In some cases, BSD/RCTA may not work correctly under the following conditions.• In bad w ...
Inspection
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > General DescriptionINSPECTION1. BASIC INSPECTIONBefore performing diagnosis, check the following items that might provoke the problems ...
Other materials:
Starting engine
CAUTION
Do not operate the starter motor
continuously for more than 10 seconds.
If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
NOTE
It may be difficult to start the engine
when the battery has been disconnecte ...
Operation
TELEMATICS SYSTEM (DIAGNOSTICS) > Subaru Select MonitorOPERATION• For detailed operation procedures, refer to “Application help”.• When DCM cannot establish communication with Subaru Select Monitor, perform “COMMUNICATION FOR INITIALIZING IMPOSSIBLE”. Subaru S ...
Gasoline for California-certified
LEV
If your vehicle was certified to California's
low emission vehicle (LEV) standards as
indicated on the underhood tune-up label,
it is designed to optimize engine and
emission performance with gasoline that
meets the clean burning low-sulfur California
gasoline specifications. If you live in
a ...