TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Circuit tester | Used for measuring resistance, voltage and current. |
Transmitter registration tool | Used to register the transmitter ID. Manufacturer: Kent-Moore Item number: J45295 |
DST-i | Used together with Subaru Select Monitor 4. |
Installation
EXHAUST(H4DO) > Front Exhaust PipeINSTALLATION1. Set the front exhaust pip and center exhaust pipe to the vehicle, and temporally tighten the nuts which secure the front exhaust pipe to cylinder head.NOTE:Use a new gasket.2. Install the bolts, springs, and nuts which secure the rear exhaust pipe ...
Dtc b1862 short in driver s knee airbag (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1862 SHORT IN DRIVER’S KNEE AIRBAG (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to ground.• Knee airbag module harness c ...
Relay and fuse
Inspection
CRUISE CONTROL SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness. Location
CRUISE CONTROL SYSTEM > Relay and FuseLOCATIONRelay & f ...