FRONT SUSPENSION > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
927680000
INSTALLER & REMOVER SET
Used for replacing the bushing front - front arm of front arm assembly.
20299AG000
REMOVER
• Used for replacing the bushing rear - front arm of front arm assembly.
• Used together with BASE (20299AG010).
20299AG010
BASE
• Used for replacing the bushing rear - front arm of front arm assembly.
• Used together with REMOVER (20299AG000).
20299AG020
STUD BOLT SOCKET
Used for removing and installing the stud bolt for front arm assembly installing portion.
20399AG000
STRUT MOUNT SOCKET
Used for disassembling and assembling strut mount.
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
DST-i | Used together with Subaru Select Monitor 4. |
Alignment gauge adapter | Used for measuring wheel alignment. |
Turning radius gauge | Used for measuring wheel alignment. |
Toe-in gauge | Used for toe-in measurement. |
Tie-rod end puller | Used for disconnecting tie-rod end. |
Dial gauge | Used for damper strut measurement. |
Coil spring compressor | Used for strut assembly/disassembly. |
Seat fabric
Remove loose dirt, dust or debris with a
vacuum cleaner. If the dirt is caked on the
fabric or hard to remove with a vacuum
cleaner, use a soft brush then vacuum it.
Wipe the fabric surface with a tightly
wrung cloth and dry the seat fabric
thoroughly. If the fabric is still dirty, wipe
usi ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveASSEMBLY1. Install the return spring (1st-2nd), return spring cap, reverse accent shaft, reverse check cam, return spring (5th-Reverse) and reverse check spring.NOTE:Be sure to insert the curved part of reverse check spring into the ...
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3. ...