Subaru Crosstrek Service Manual: Preparation tool
DRIVE SHAFT SYSTEM > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | PART NO. | DESCRIPTION | REMARKS |
20099PA010
INSTALLER & REMOVER
• Used for replacing the rear bushing of rear axle housing.
• Used together with BUSHING REMOVER (20099FG000).
20099FG000
BUSHING REMOVER
• Used for replacing the rear bushing of rear axle housing.
• Used together with base part of INSTALLER & REMOVER (20099PA010).
28099AC000
BOOT BAND PLIERS
Used for tightening the boot band.
(For front drive shaft)
925091000
BAND TIGHTENING TOOL
Used for tightening the boot band.
(A) Jig for the band
(B) Ratchet wrench
18675AA000
DIFFERENTIAL SIDE OIL SEAL INSTALLER
Used for installing the differential side retainer oil seal.
926470000
AXLE SHAFT PULLER
• Used for removing the drive shaft.
• Used together with AXLE SHAFT PULLER PLATE (28099PA110).
28099PA110
AXLE SHAFT PULLER PLATE
Exchange with the plate of the AXLE SHAFT PULLER (926470000) to use.
927080000
HUB STAND
Used for assembling hub bolt in hub.
28399AG000
HUB STAND
Used for extracting hub bolt.
28399SA010
OIL SEAL PROTECTOR
• Used for installing front drive shaft into front differential.
• For protecting the oil seal.
28099PA090
OIL SEAL PROTECTOR
• Used for installing the rear drive shaft to the rear differential.
• For protecting the oil seal.
28099PA100
DRIVE SHAFT REMOVER
Used for removing the rear drive shaft from rear differential. (T-type)
2. GENERAL TOOL
TOOL NAME | REMARKS |
Tie-rod ball joint puller | Used for disconnecting joints. |
Dial gauge | Used for inspecting the propeller shaft run-out. |
Extension cap | Used for preventing leakage of gear oil or CVTF. |
Crowbar | Used for extracting drive shaft. |
Needle nose pliers | Used for tightening the boot band of the rear drive shaft. |
• Snap-on 96BCP
Or equivalent.
Component
DRIVE SHAFT SYSTEM > General DescriptionCOMPONENT1. PROPELLER SHAFT(1)Propeller shaft(3)Rear differential (T-type)Tightening torque: N·m (kgf-m, ft-lb)(2)Rear differential (VA1-type) T1:31 ...
Propeller shaft
...
Other materials:
Inspection
BRAKE > Brake PedalINSPECTION1. Move the pad - brake pedal in a horizontal direction with a force of approx. 10 N (1 kgf, 2 lbf), and check that the pedal deflection is in the range of specifications.CAUTION:If excessive deflection is noted, replace with a new bushing.Deflection of brake pedal:We ...
List
EyeSight (DIAGNOSTICS) > EyeSight Temporary Code(s) DisplayLIST• List of EyeSight temporary stop codeEyeSight pause codeItemContents of diagnosisReferenceE5Stereo Camera Temporary StopThe operation stopped temporarily due to vertical deviation of the optical axis of the stereo camera. (Duri ...
Installation
ENTERTAINMENT > Data Communication ModuleINSTALLATION1. DATA COMMUNICATION MODULECAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system compone ...