Subaru Crosstrek Service Manual: Preparation tool
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
18460AA040
CHECK BOARD
Used for measuring voltage and resistance of TCM terminals.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Circuit tester | Used for measuring resistance, voltage and current. |
Oscilloscope | Used for measuring the sensor. |
DST-i | Used together with Subaru Select Monitor 4. |
Caution
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > General DescriptionCAUTION1. The airbag system wiring harness is routed near the TCM.CAUTION:• All the airbag system wiring harnesses and co ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > General DescriptionINSPECTION1. BATTERYCheck the battery. Battery > INSPECTION">2. TRANSMISSION GROUNDMake sure that the ground termin ...
Other materials:
Where to place a child restraint system
The following are SUBARU's recommendations
on where to place a child restraint
system in your vehicle.
A: Front passenger's seat
You should not install a child restraint
system (including a booster seat) due to
the hazard to children posed by the
passenger's airbag.
B: Rear seat, window- ...
Dtc u0131 lost communication with power steering control module
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0131 LOST COMMUNICATION WITH POWER STEERING CONTROL MODULEDetected when CAN data is not received from electric power steering CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Pro ...
Inspection
LIGHTING SYSTEM > SRF OFF SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3OFF1 M? or moreONLess than 1 ?2. Apply battery voltage between the connector terminals to check lighting condition of illu ...
