CLUTCH SYSTEM > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |

498497100
CRANKSHAFT STOPPER
Used for stopping rotation of the flywheel.

499747100
CLUTCH DISC GUIDE
Used for installing the clutch disc to the flywheel.

—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Circuit tester | Used for measuring resistance, voltage and current. |
Dial gauge | Used for measuring clutch disc run-out. |
Depth gauge | Used for measuring clutch disc wear. |
Angle gauge | Used for tightening the flywheel. |
DST-i | Used together with Subaru Select Monitor 4. |
Component
Master cylinderInspection
BRAKE > Stop Light SwitchINSPECTION1. CLEARANCE CHECKNOTE:Check for clearance is applied only to LED model.1. Measure the clearance between the end of the stop light switch and the stopper.Specification:Clearance (A) of the stop light switch: 1 mm — 2 mm (0.04 in — 0.08 in)(a)Stop light switc ...
Removal
EXHAUST(H4DO) > Front Exhaust PipeREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL"> ...
Installation
EXTERIOR/INTERIOR TRIM > Roof MoldingINSTALLATION1. Remove the clips from the molding - roof, and attach to the studs on the vehicle.CAUTION:• Always replace the clips that were damaged during removal of the molding - roof with new parts.• While installing the molding - roof, be caref ...