MECHANICAL(H4DO) > Preparation for Overhaul
PROCEDURE
1. After removing the engine from the vehicle body, attach the ST to the engine as shown in the figure.
NOTE:
When using a commercially sold engine stand, follow the instructions of engine stand used.
Tightening torque:
35 N·m (3.6 kgf-m, 25.8 ft-lb)
ST1 498457000 | ENGINE STAND ADAPTER RH |
ST2 498457100 | ENGINE STAND ADAPTER LH |
ST3 18362AA020 | ADAPTER |
ST4 499817100 | ENGINE STAND |
2. In this section the procedures described under each index are all connected and stated in order. The procedure for overhauling of the engine will be completed when you go through all steps in the process.
Therefore, in this section, to conduct the particular procedure within the flow of a section, you need to go back and conduct the procedure described previously in order to do that particular procedure.
Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Read Current DataOPERATION1. COMBINATION METER1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Se ...
Select play mode
The play mode settings display will appear
when play mode key is touched. Select
the preferred play mode from the following
items.
Icon
Function
Touch to start 1 track repeat.
Touch to start repeat all.
Touch to repeat the tracks in the
group.
...
Clock
To adjust the time shown by the clock,
press the "+" button or "−" button. If you
press the "+" button, the indicated time will
change in one-minute increments. If you
press the "−" button, the indicated time will
change in one-minute decrements. If you
keep the button pressed, ...