MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Preparation for Overhaul
PROCEDURE
1. Clean oil, grease, dirt and dust from the transmission.
2. When transmission gear oil remains in the transmission, using the TORX® bit T70, remove the drain plug, and drain the gear oil completely.
3. Attach the drain plug using TORX® bit T70.
NOTE:
Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, silver)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (copper gasket, brown)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (metal gasket, black)
4. Attach the transmission to the ST.
ST 499937100 | TRANSMISSION STAND |
5. Apply transmission gear oil to rotating parts before assembly.
6. All disassembled parts, if to be reused, should be reinstalled in the original positions.
7. Gaskets, lock washers and lock nuts must be replaced with new ones.
8. Apply liquid gasket to the specified areas to prevent leakage.
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchDISASSEMBLY1. Remove the snap ring, and then remove the pressure plate, drive plate and driven plate.(A)Snap ring2. Compress the return spring using the ST to remove the snap ring.ST 18762AA001COMPRESSOR SPECIAL TOOL(A)Snap ring(B)Tran ...
Dtc b2286 engine speed signal(without auto start stop)
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2286 ENGINE SPEED SIGNAL(WITHOUT Auto Start Stop)DTC detecting condition:When the engine speed signal transmitted from the ECM via solid line and the engine speed signal transm ...
Profiles
This system supports the following services.
NOTE
If your cell phone does not support HFP, registering the Bluetooth
phone or using OPP, PBAP, or SPP profiles individually
will not be possible.
If the connected Bluetooth device version is older than recommended
or incompatible, the ...