1. Turn off the ignition switch.
2. Close all doors (including rear gate).
3. Press and hold the "
"
button on the
access key. All doors (including rear gate)
will then be locked.
4. Keep the "
" button
pressed, and
press the rear lock button within 5
seconds after step 3.
5. Press and hold the above button for more than 5 seconds. Then a chirp will sound.
6. Release the "
" button and rear
lock
button.
7. Press the "
" button on the
access key
while the chirp sounds.
Then the chirp will stop and the preparation is complete.
NOTE
If you do not press the "
"
button on
the access key, the chirp will sound for
30 seconds. In this case, the preparation
for registering a PIN code does not
complete even if the chirp stops.
RegistrationRemote engine start system (dealer
option)
WARNING
There are some general precautions
when starting the engine.
Carefully read the precautions
described in "General precautions
when starting/stopping engine"
F7-9.
Do not remote start a vehicle in
an enclosed environment (e.g.
closed garage). Prolonged operation
of a mot ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission HarnessINSPECTION1. Visually check the harness and connector for damage or crack.2. Check the harness terminal for rust, disconnection or poor contact.3. Check the continuity between harness terminals.NOTE:For details of transmission harnes ...
Operation
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlOPERATION1. While the VDC sequence control is performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve is operated.2. VDC sequence control can be started by S ...